When installing the gas generator set, we must pay attention to some problems and installation precautions, so that we can use the set more conveniently. Here are the installation precautions of gas generator set introduced by HuaQuan power!

1、安裝地點注意通風，發電機機房遠離明火區域；

1. Pay attention to ventilation at the installation site and keep the generator room away from the open fire area;

2、機房周圍保持清潔，避免放置酸性、堿性等腐蝕性氣體；

2. Keep the surrounding of the machine room clean and avoid placing acidic, alkaline and other corrosive gases;

3、機房內要達到消防要求，配備滅火器等設備；

3. The machine room shall meet the fire-fighting requirements and be equipped with fire extinguishers and other equipment;

4、燃?xì)獍l(fā)電機組外殼一定要有可靠的保護接地，并配置防雷裝置；

4. The shell of gas generator set must have reliable protective grounding and be equipped with lightning protection device;

5、發電機與市電的雙向開關一定是十分可靠，以防倒送電。雙向開關的接線可靠性需經過當?shù)毓╇姴块T的檢驗認；

5. The two-way switch between the generator and the mains must be very reliable to prevent reverse power transmission. The wiring reliability of two-way switch shall be inspected and recognized by the local power supply department;

一般用戶對燃?xì)獍l(fā)電機組的安裝注意事項了解的很少，即使是了解，操作起來也會有困難，因此遇到不了解的情況的話一定要聯系技術人員進行操作。

General users know little about the installation precautions of gas generator set. Even if they do, it will be difficult to operate. Therefore, if they do not know, they must contact technicians for operation.

怎樣調整并列機組的逆功現象？

How to adjust the reverse power phenomenon of parallel units?

當兩臺發電機組空載并列后，會在兩臺機組之間，產生一個頻率差與電壓差的問題。并且在兩臺機組的監視儀表上（電流表、功率表、功率因數表），反應出實際的逆功情況，一種是轉速（頻率）不一致造成的逆功，另一種是電壓不等造成的逆功，其調整如下：

When two generator units are paralleled without load, there will be a problem of frequency difference and voltage difference between the two units. Moreover, the monitoring instruments of the two units (ammeter, power meter and power factor meter) reflect the actual reverse work. One is the reverse work caused by inconsistent speed (frequency) and the other is the reverse work caused by unequal voltage. The adjustment is as follows:

1．頻率造成逆功現象的調整：如果兩臺機組的頻率不等，相差較大時，在儀表上（電流表、功率表）顯示出，轉速高的機組電流顯示正值，功率表指示為正功率，反之，電流指示負值，功率指示負值。這時調整其中一臺機組的轉速（頻率），視功率表的指示進行調整，把功率表的指示調整為零即可。使兩臺機組的功率指示均為零，這樣兩臺機的轉速（頻率）基本上一致。但是，這時電流表仍有指示時，這就是電壓差造成的逆功現象了。

1. Adjustment of reverse work caused by frequency: if the frequencies of two units are different and the difference is large, the instrument (ammeter and power meter) shows that the current of the unit with high speed displays positive value and the power meter indicates positive power. On the contrary, the current indicates negative value and the power indicates negative value. At this time, adjust the speed (frequency) of one unit according to the indication of the power meter, and adjust the indication of the power meter to zero. Make the power indication of the two units zero, so that the speed (frequency) of the two units is basically the same. However, when the ammeter still has indication, this is the reverse power phenomenon caused by voltage difference.

2．電壓差造成逆功現象的調整：當兩臺機組的功率表指示均為零時，而電流表仍然有電流指示（即一反一正指示）時，可調整其中一臺發電機組的電壓調整旋鈕，調整時，視電流表與功率因數的指示進行。將電流表的指示取消（即調整為零），電流表無指示后，這時視功率因數表的指示，把功率因數調至滯后0.5以上即可.一般可調整至0.8左右。

2. Adjustment of reverse work caused by voltage difference: when the indication of the power meter of two units is zero and the ammeter still has current indication (i.e. one reverse and one positive indication), the voltage adjustment knob of one generator unit can be adjusted according to the indication of the ammeter and power factor. Cancel the indication of the ammeter (i.e. adjust it to zero), and after the ammeter has no indication, adjust the power factor to more than 0.5 lag according to the indication of the power factor meter Generally, it can be adjusted to about 0.8.

以上就是為大家介紹的有關燃?xì)獍l(fā)電機組配件的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以專業的態度,為您提供服務http://www.dgtmcnc.com

The above is a detailed introduction to the accessories of gas generator set. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.dgtmcnc.com