1、 Check the start solenoid valve. When the generator is running, people have summed up a set of inspection methods of "one look, two listen, three touch and four smell". Listening at startup is a very important step. Take the original Cummins generator in the United States as an example. Just press the start button and start it after three seconds. Two "clicks" can be heard within three seconds. Once the second sound is not heard, check whether the starting solenoid valve works normally. If the solenoid coil is burnt out, of course, the generator cannot be started.

二，電池組的檢查。由于備用電源不是經常投入使用，發電機是否能正常啟動，關鍵在于電池的維護保養。如電池組出現了問題，比較常見的情況是：有電壓無電流，這時可以聽到啟動電機內電磁閥吸合的聲音，但帶不動連軸。電池組出現問題導致無法停機原因有三：1.在試機時采用停止為電池充電的方式，會導致電池電量不足。2.采用機械油泵由皮帶傳動，額定轉速下的泵油量很大，然而電池組供電不足，導致停機時截流閥里的彈簧片由于電磁閥吸力不夠而不能封死從四個出油孔噴出的燃油，造成不能停機。3.國產電池通常壽命為兩年，沒有定期更換。

2、 Inspection of battery pack. Since the standby power supply is not often put into use, the key to whether the generator can start normally lies in the maintenance of the battery. If there is a problem with the battery pack, the more common situation is: there is voltage and no current. At this time, the sound of the solenoid valve in the starting motor can be heard, but the coupling cannot be moved. There are three reasons why the battery pack cannot be shut down due to problems: 1 Stopping charging the battery during test run will lead to insufficient battery power. 2. The mechanical oil pump is driven by the belt, and the amount of pump oil at the rated speed is large. However, the power supply of the battery pack is insufficient, resulting in the failure of the spring plate in the shut-off valve to seal the fuel ejected from the four oil outlet holes due to the insufficient suction of the solenoid valve during shutdown, resulting in the failure of shutdown. 3. Domestic batteries usually have a service life of two years and are not replaced regularly.

三，柴油、潤滑油的檢查。因為機組長期處于靜態，機組本身各種材料會與機油、冷卻水、柴油、空氣等發生復雜的化學、物理變化，從而將機組“放”壞。為此應注意油的問題。為了消防安全，通常都把柴油油箱放在一個密閉的房間內，由于大氣中水氣因溫度的變化而發生冷凝現象，結成水珠掛附在油箱內壁，流入柴油中，致使柴油含水量超標，這樣的柴油進入柴油機高壓油泵，會銹蝕精密耦合件———柱塞，嚴重?fù)p壞機組。

3、 Inspection of diesel and lubricating oil. Because the unit is static for a long time, various materials of the unit itself will undergo complex chemical and physical changes with engine oil, cooling water, diesel oil, air, etc., which will "blow" the unit. Therefore, attention should be paid to the problem of oil. For the sake of fire safety, the diesel oil tank is usually placed in a closed room. Due to the condensation of water and gas in the atmosphere due to the change of temperature, water droplets form and hang on the inner wall of the oil tank and flow into the diesel, resulting in the water content of the diesel exceeding the standard. When such diesel enters the high-pressure oil pump of the diesel engine, it will rust the precision coupling plunger and seriously damage the unit.

1、安裝地點需通風良好，發電機端應有足夠的進風口，柴油機端應有良好的出風口。出風口面積應大于水箱面積1.5倍以上。

1. The installation site shall be well ventilated. There shall be sufficient air inlet at the generator end and good air outlet at the diesel engine end. The air outlet area shall be more than 1.5 times larger than the water tank area.

2、安裝地的周圍應保持清潔，避免在附近放置能產生酸性、堿性等腐蝕性氣體和蒸汽的物品。有條件的應配置滅火裝置，消防還是有必要重視的。

2. The surroundings of the installation site shall be kept clean and articles that can produce acidic, alkaline and other corrosive gases and vapors shall not be placed nearby. If conditions permit, fire extinguishing devices should be equipped, and fire fighting is still necessary to pay attention to.

3、在室內使用，必須將排煙管道通導室外，管徑必須≥消音器的出煙管直徑，所接之管路的彎頭不宜超過3個，以保證排煙暢通，并應將管子向下傾斜5-10度，避免雨水注入；若排氣管時垂直向上安裝的，則必須加裝防雨罩。

3. For indoor use, the smoke exhaust pipe must be connected to the outside, the pipe diameter must be ≥ the diameter of the smoke outlet pipe of the silencer, and the elbow of the connected pipeline should not exceed 3 to ensure smooth smoke exhaust, and the pipe should be inclined downward by 5-10 degrees to avoid rainwater injection; If the exhaust pipe is installed vertically upward, a rain cover must be installed.

4、基礎采用混凝土?xí)r，在安裝時須用水平尺測其水平度，使機組固定于水平的基礎上。機組與基礎之間應有專用防震墊或用底腳螺栓。

4. When the foundation adopts concrete, the levelness must be measured with a level ruler during installation to fix the unit on a horizontal foundation. Special shockproof pads or foot bolts shall be provided between the unit and the foundation.

5、機組外殼必須有可靠的保護接地，對需要有中性點直接接地的發電機，則必須由專業人員進行中性接地，并配置防雷裝置，嚴禁利用市電的接地裝置進行中性點直接接地。

5. The shell of the unit must have reliable protective grounding. For the generator that needs to be directly grounded at the neutral point, the neutral grounding must be carried out by professional personnel and equipped with lightning protection device. It is strictly prohibited to use the grounding device of municipal power for direct grounding at the neutral point.

本文的精彩內容由燃?xì)獍l(fā)電機組提供知識提供，本網站還有很多的精彩內容，更多的內容您可以點擊進入：http://www.dgtmcnc.com我們有專門的客服為您解答問題

The wonderful content of this article is provided by the gas generator set. There are many wonderful contents on this website. You can click to enter more contents: http://www.dgtmcnc.com We have special customer service to answer your questions