The temperature control of the generator set room is very important. Although the unit has its own cooling system, continuous operation for a long time will still affect the temperature of the machine room. Therefore, it is recommended that you pay attention to the design of the machine room. The specific treatment methods are as follows:

1、當室內外空氣溫差較小且水量不足時，宜采用直接蒸發式冷風機組降低發電機房溫度。

1. When the temperature difference between indoor and outdoor air is small and the amount of water is insufficient, direct evaporative cooling fan unit should be used to reduce the temperature of generator room.

2、當水量充足且水溫能滿足要求時，宜采用水冷方式降低發電機房溫度；

2. When the water quantity is sufficient and the water temperature can meet the requirements, water cooling should be adopted to reduce the temperature of the generator room;

3、當室內外空氣溫差較大時，宜利用室外空氣降低發電機房溫度；

3. When the temperature difference between indoor and outdoor air is large, outdoor air should be used to reduce the temperature of generator room;

若是移動電站控制室需要通風，應按下述不同情況分別處理：

If ventilation is required in the control room of mobile power station, it shall be handled according to the following different conditions:

1、當移動電站與防空地下室連成一體時，應從防空地下室內向電站控制室供給新風；

1. When the mobile power station is integrated with the air defense basement, fresh air shall be supplied from the air defense basement to the power station control room;

2、當移動電站獨立設置時，控制室應由電站設置獨立的通風系統供給新風，且應設濾毒通風裝置。

2. When the mobile power station is set independently, the control room shall be provided with independent ventilation system to supply fresh air, and poison filtering ventilation device shall be set.

3、移動電站的貯油間應設排風裝置，排風換氣次數不應小于每小時5次，接至貯油間的排風管道上應設70℃關閉的防火閥。

3. The oil storage room of the mobile power station shall be equipped with an exhaust device, and the number of exhaust and air exchange shall not be less than 5 times per hour. The exhaust pipe connected to the oil storage room shall be equipped with a fire damper closed at 70 ℃.

發電機組的水過濾相信大家都很熟悉，但是水過濾到底有什么作用呢?

I believe everyone is familiar with the water filtration of generator set, but what is the role of water filtration?

1、減少穴蝕和**腐蝕。向發電機冷卻系統補充非常有用的化學劑，維護冷卻液具有合適的添加劑濃度，減少機缸套、水泵葉輪等零件穴蝕和**水泵葉輪及其殼體，冷卻系統彎接頭和管子以及熱交換器、散熱器、機油冷卻器、中冷器管子用期端蓋等零部件的腐蝕。

1. Reduce pitting and * * corrosion. Replenish very useful chemicals to the cooling system of the generator, maintain the coolant with appropriate additive concentration, and reduce the cavitation corrosion of the cylinder liner, water pump impeller and other parts, and the corrosion of * * water pump impeller and its shell, bending joints and pipes of the cooling system, as well as the end caps of heat exchangers, radiators, oil coolers and intercooler pipes.

2、保持冷卻液具有合適的酸堿性或PH值。

2. Keep the coolant with proper acidity and alkalinity or pH value.

3、防止堵塞和積垢。用化學物質軟化冷卻液，防止在傳達室熱零部件水側表面形成積垢而引起缸蓋炸裂，活塞環磨損嚴重等，防止沉淀物堵塞熱交換器和散熱器管子及缸體和缸蓋中的冷卻液通道。

3. Prevent clogging and fouling. Soften the coolant with chemicals to prevent the formation of scale on the water side surface of hot parts in the transfer room, which will cause the cylinder head to burst and the piston ring to be seriously worn, and prevent the sediment from blocking the coolant channels in the heat exchanger and radiator pipes, cylinder block and cylinder head.

4、減少磨損。濾除冷卻液中的泥芯砂、淤泥、機油、礦物性水垢、鐵銹、變質的添加劑沉淀物和密封件碎塊等雜質，減少水泵與水泵殼體之間、缸套縫隙密封圈、水泵水封（端面密封）、調（節）溫器與調溫器殼體以及調溫器密封圈等零件的磨損。

4. Reduce wear. Filter out the impurities such as mud core sand, sludge, engine oil, mineral scale, rust, deteriorated additive sediment and seal fragments in the coolant, and reduce the wear of parts such as water pump and water pump shell, cylinder liner gap seal ring, water pump water seal (end face seal), thermostat and thermostat shell and thermostat seal ring.

5、可以用來診斷發動機故障并確定故障發源處。

5. It can be used to diagnose engine faults and determine the source of faults.

6、**變臟.。通過對發動機冷卻液中的泥芯砂、淤泥、機油、礦物質水垢、變質的添加劑沉淀物等的過濾可以**調溫器、水溫傳達室感器和水加熱器零件表面變臟。

6. * * dirty. By filtering the mud core sand, sludge, engine oil, mineral scale, deteriorated additive sediment, etc. in the engine coolant, the surfaces of thermostat, water temperature sensor and water heater parts can become dirty.

水濾器的存在，本身可以提醒用戶保護好冷卻系統經，并向冷卻液中補充化學添加劑，對冷卻系統進行良好的維護保養。

The existence of water filter can remind users to protect the cooling system, supplement chemical additives to the coolant and maintain the cooling system well.

以上就是為大家介紹的有關生物質氣發電機組的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以專業的態度,為您提供服務http://www.dgtmcnc.com

The above is the introduction of biomass generator set. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.dgtmcnc.com